2018-08-02
155-015M-A
2SF24 and 2SF30
Preparation and Setup
22
Gauge Wheel Adjustments for Leveling Drill
Refer to Figure 11 and Figure 12
The openers near the outside of the drill are adjusted by
raising or lowering the gauge wheels.
Raise the drill out of the ground and loosen the jam nut
located near the bottom clevis of the gauge wheel
turnbuckle. This turnbuckle is threaded to allow easy
gauge wheel adjustment.
•
Lengthening the turnbuckle the gauge wheel is
lowered, causing less spring rod extension through
the spring rod casting.
•
Shortening the turnbuckle the gauge wheel is raised,
causing less spring rod to protrude through the
spring rod casting.
After adjusting, be sure the turnbuckle on both gauge
wheel arms have the same pin center dimension.
Shortening the gauge wheel turnbuckle will level the
ends of the drill with the center.
Box Alignment Adjustments
Pull Bar Adjustments
With the drill lowered to the ground and completely
unfolded the tongue slide on the tongue should be back
against the stop on the tongue. Adjust the pull bars
length so drill boxes are in line with one another and
parallel to the back edge of the main frame.
Figure 12
Gauge Wheel Turnbuckle
10546
Figure 13
Opener Spring Rods
11284
