Retro Call @1970 Bluetooth
Instruction Manual
How to get started & synchronisation with mobile phones
2
English
Hold the
Retro Call @1970 Bluetooth
telephone receiver near your mobile phone and press
the ON/OFF button for approximately five seconds. The status light will light up in yellow
and red alternately. "Phone 01" will be shown on the display of your mobile phone once it
has recognised the
Retro Call @1970 Bluetooth
telephone receiver.
7.
(continued from page 1)
Confirm the "Phone 01" device on your mobile phone. After that, you will be prompted to
enter an ID. Type in "0000".
8.
Once the
Retro Call @1970 Bluetooth
telephone receiver has been successfully synchro-
nised with your mobile phone, the red status light will indicate that the receiver is ready to
operate.
9.
You only need to register the receiver once. In order to use the receiver, please ensure that
Bluetooth is activated on your mobile phone, that the receiver is switched on and that the
product has been registered as a device.
10.
Additional operating advice
Switch on:
Press the ON/OFF button for approximately five seconds.
Answer calls:
You can answer phone calls directly with the
Retro Call @1970 Bluetooth
telephone receiver. Simply press the ON/OFF button. A beep confirms that the call has been
taken.
Make a call:
Use your mobile phone as you normally would. Depending on the make, the
mobile phone might ask you if you wish to talk directly through your mobile phone or with the
receiver.
Adjust volume:
You can adjust the volume whilst being on the phone. Simply press the
volume control buttons on your receiver.
Hang up:
To hang up press the ON/OFF button. A beep confirms that the call has finished.
Switch off:
Press the ON/OFF button for approximately five seconds. The status light displays
to confirm that the receiver has been switched off.
Reach:
The reach between your mobile phone and the receiver is approximately ten meters.
Status light:
Battery is being charged – red LED on
Battery fully charged – red LED off
Synchronisation with your mobile phone: red and yellow LED in turns
Bluetooth connection activated – red LED blinks slowly