Page 5
STEP 1:
INSTALL 1- 5/16” X 1 ¼” BOLT, 2 FLAT WASHERS AND LOCKNUT INTO MIDDLE HOLE OF THE LEFT AND
RIGHT ANGLE BRACKETS (BRACKETS WITH THREE HOLES ON ONE SIDE). TIGHTEN COMPLETELY.
NOTE: THIS BOLT WILL ACT AS A HORIZONTAL REST WHEN INSTALLED
. SEE FIG. 1 & 2
STEP 2:
REMOVE THE BOTTOM ALLEN BOLT SECURING ROLL BAR SECTIONS ON EACH SIDE OF POLARIS.
STEP 3:
INSTALL THE BRACKET TO EACH SIDE OF RANGER USING 1- 5/16” X 3 ½” BOLT AND 12 FLAT WASHERS
AND LOCKNUT.
NOTE:
10 OF THE FLAT WASHERS ARE TO BE USED BETWEEN ANGLE BRACKET AND ROLL BAR. THESE WILL
FILL THE VOID LEFT BY THE HEAD OF THE REMOVED ALLEN BOLT.
SEE FIG. 3
FIG. 1
FIG. 2
BOLT WILL PROTRUDE THROUGH INSIDE OF ROLL BAR. TIGHTEN ALL ASSEMBLIES. BRACKETS
SHOULD SIT HORIZONTAL TO THE GROUND
.
SEE FIG.4
FIG. 3
FIG. 4
REFER BACK TO STEP 2 OF INSTRUCTION MANUAL FOR REMAINDER OF INSTALLATION
.