Assembly - 67
ASSEMBLY
Initial Adjustments
1. Check free-wheel valves on both pump assemblies to
make sure that the valves are closed. Tighten valves to
108-163 N•m (80-120 lb-ft).
2. Raise the rear of the machine until the drive wheels are
off the ground. Support the machine with jackstands.
3. Start and run the engine until it reaches normal
operating temperature.
4. Move control levers to the forward position and observe
drive wheel rotation; the drive wheels should rotate in the
correct direction.
5. Move the control levers to the reverse position and
observe drive wheel rotation; the drive wheels should rotate
in the correct direction.
6. Move PTO clutch switch to on position; mower clutch
should engage. Run blades for several minutes.
7. Move PTO clutch switch to off position and shut the
engine off.
8. Check all belts for proper tension.
9. Start the engine and test drive the machine in an open
area. Drive the machine forward; if the machine drifts to the
right or left, adjust the transmission control linkage.
c
CAUTION: Avoid injury! Clear area of
bystanders before performing this service
procedure.
c
CAUTION: Avoid injury! Engine exhaust fumes
contain carbon monoxide and can cause
serious illness or death.
Move the vehicle to an outside area before
running the engine.
Do not run an engine in an enclosed area
without adequate ventilation.
•
Connect a pipe extension to the engine
exhaust pipe to direct the exhaust fumes out of
the area.
•
Allow fresh outside air into the work area to
clear the exhaust fumes out.
Summary of Contents for Chariot / Chariot LX GDRZ48-17KAE
Page 58: ...Service Electrical 54 SERVICE ELECTRICAL Wiring Schematic Carbureted Engines MX15338...
Page 59: ...Service Electrical 55 SERVICE ELECTRICAL Wiring Schematic 26 HP Fuel Injected Engine MX15345...
Page 60: ...Service Electrical 56 SERVICE ELECTRICAL Wiring Schematic 28 HP Fuel Injected Engine MX15356...