Light Bar Assembly
1.
Locate string taped to the side of the Power Hockey table.
2.
Remove tape and pull out wire harnesses attached to the string.
3.
Attach Light Bar with wire to the side on the table with exposed wire harnesses, using
(6) 1 1/2” x 1/4” #20 bolts and 6 locking washers.
4.
Attach remaining Light Bar to the other side of the table in the same way.
5.
Attach Light Fixture to the Light Bars using: (4) 1
/4” x 1/4” #20 bolts, (8) 1/4” washers,
(4) 1/4” locking washers, and (4) 1/4” nuts. (See figure 2)
6.
Connect wires from Light Fixture (2 pin connector) to matching connector in Light Bar.
7.
Attach 25 pin harness from light bar to the Score Panel at connector marked
“
INTERFACE
”. NOTE: Make sure the notches on the harness face center of the
circuit board when you attach it to the board.
8.
Screw score panel to the light assembly with (4) 5/8” #8 pan head screws.
9.
Connect three wire harnesses to their mates at the base of the light bar.
10.
Attach Large Light Bar Mount Cover at the base of the Light Bar with the wires using
(2) 5/8” #8 pan head screws.
11.
Attach the Small Light Bar Mount Cover on the opposite side.
FIGURE 2
Score Panel
5/8” pan head screw
1/4” nut
Light Bar
1”
1/4” locking washer
1/4” washer
Light Fixture
1/4” washer
1/2” x 1/4” #20 bolt
