7
UNPACKING UNIT
IMPORTANT:
Remove contents from carton carefully.
Place cover assembly on a flat piece of cardboard to
avoid scratching it.
Package Contents:
Check the contents of your kit for the parts listed below
and shown in Figures 3 – 6.
INSTALL FRONT WEIGHT TRAY &
COUNTERWEIGHT
1. Remove the front footrest. There are two 1/2 x 2"
(item 9) and 5/16 x 1" (item 5) round head square
neck bolts that secure the footrest to the chassis.
The 1/2 x 2" bolts (item 9) and metal spacers are
held on the footrest by two 1/2" push nuts (item 11).
Twist or cut off the push nuts to remove. Save the
spacers and discard all other hardware. See
Figure 4.
2. Lay the footrest onto the back of the weight tray
(similar profile). It may be helpful to have the weight
tray laying upside down on the ground when mating
it to the footrest. Install two 1/2 x 2" bolts (item 9)
thru the front of the weight tray and footrest. Slide
the two spacers (from step 1) over the bolts and
secure with push nuts (item 11). Secure the push
nuts as tight as possible. See Figure 4.
ASSEMBLY
WARNING:
AVOID INJURY. Read and
understand the entire
Safety
section before
proceeding.
Item
Description
Qty
Part
Number
1
Weldment Bagger Weight Tray
1
04215451
2
Mesh Bag
2
03862900
3
Grip, Adhesive
1
03833800
4
Cast Iron Weight
1
00172000
5
5/16 x 1" Round Head Square
Neck Bolt
2
06216100
6
5/16-18 Nyloc Nut
2
06545400
7
3/8-16 x 3" Hex Bolt
2
05957800
8
3/8" Lock Washer
4
06308800
9
1/2 x 2" Round Head Square
Neck Bolt
2
06200205
10
1/2" Nyloc Flange Nut
4
06500010
11
1/2" Push Nut
2
06500705
12
.515 x 1.625 x .250 Flat Steel
Washer
6
06445000
13
.438 x 1.00 x .083 Flat Steel
Washer
4
06435900
14
.390 x 1.5 x .125 Flat Steel
Washer
2
06441700
15
Locking Bow Tie Cotter Pin
.091 x 7.875
4
06700201
16
Wing Knob
1
07500225
17
Studded Wing Knob
1
07500226
18
34" Boot Assembly (815040)
1
51577500
42" Boot Assembly (815041)
1
51577600
50" Boot Assembly (815042)
1
51577700
19
L Bracket, Brace & Hardware
1
N/A
20
Bagger Hose (815040)
Bagger Hose (815041, 042)
1
04445600
04222900
21
Hood Assembly
1
51577800
22
Receiver & Hardware
1
N/A
23
Bag Frame
2
00663200
24
Plastic Tube, 3/8 x 1/2 x 3"
2
00677000
WARNING:
ALWAYS install counterweight
before operating unit with bagger attached.
ALWAYS remove counterweight when bagger is
removed from unit.
Figure 3
815040
815041
815042
