11
INSTALL FRAME AND HOOD ASSEMBLY
1. Install receiver to the right rear frame using two 3/8
x 1" hex bolts and two 3/8" locking nuts. Tighten
hardware. See Figure 10.
2. Insert L bracket into the receiver and fasten using
1/2 x 2 3/4" round head square neck bolt and wing
knob. Do not fully tighten. See Figure 11.
3. Install front studded wing knob into front of receiver.
Tighten studded wing knob and hardware installed
in step 2.
4. Position hood assembly over L bracket and install
onto bracket. See Figure 12.
NOTE:
It may require two people to position hood
assembly onto bracket.
5. Position bagger support bar inside of engine control
cables and attach support bar to L bracket using 1/2
x 2 3/4" hex bolt, 1/2" flat washer and 1/2" flange
nut. Flat washer is positioned between bar and L
bracket. Do not fully tighten hardware. See
Figure 13.
6. Mount front of support bar to the mower frame
using 3/8 x 3/4" clevis pin, 3/8" washer and bow-tie
locking cotter pin. Tighten hardware installed in step
5. See Figure 14.
Figure 10
Receiver
3/8 x 1" Hex Bolt &
3/8" Locking Nut
Figure 11
1/2" Studded Wing Knob
L Bracket
1/2 x 2 3/4" Hex Bolt &
1/2" Wing Knob
Figure 12
L Bracket
Hood
Assembly
Figure 13
Support Bar
Engine Control Cables
1/2 x 2 3/4" Hex
Bolt,
1/2" Flat
Washer &
1/2" Flange Nut
