GB - 13
NOTE:
The engine will not start unless the steering con-
trol levers are in the neutral position, the PTO switch is in
the “Off” position and parking brake is engaged.
Mower Lift Lever
Use the mower lift lever, located on the left
side of tractor, to raise and lower the
mower deck.
Pull the lever rearward to raise or push the
lever forward to lower the mower deck.
Release lever to hold the mower deck in
selected position.
The cutting height indicator on the right lift
cylinder shows the approximate cutting
height in inches.
Cylinder Stops
The cylinder stops ensure the same cutting height after
raising the deck to clear an obstacle. Store the stops on
the post behind the hydraulic lift cylinder. The stops come
in two (2) sizes, 1/4" (.64 cm) and 1/2" (1.27 cm).
1. Remove the cylinder stops from the post and snap
onto the lift cylinder rod.
2. Push the lift lever forward until the cylinder rests
against the cylinder stops.
Fuel Shut-Off Valve
Use this valve to control fuel flow from
left or right fuel tank.
Open the valve to operate the engine.
Turn the valve to "Off" when storing or
transporting the unit.
NOTE:
Fuel shut-off valve on EFI units
does not have an "Off" position.
Parking Brake Lever
1. Pull lever up to engage parking brake.
2. Push lever down to disengage parking
brake.
Seat Adjustments
To adjust seat forward or backward:
1. While seated, pull seat adjustment lever outward
and slide seat into desired position.
2. Release lever and slide seat forward or back to lock
seat into position.
To adjust seat suspension:
• To make seat more firm turn knob clockwise. To
make seat less firm turn knob counter clockwise.
Turn knob several turns at a time until desired
position is achieved.
Engine Oil Pressure Indicator
Indicator lights up “Red” if the oil pressure
is low. Check oil level and add if
necessary. Refer to engine manual.
Hour Meter
Records total number of hours the engine
has been run.
IMPORTANT:
Keep a record of Hour
Meter readings for recommended
Lubrication and Maintenance intervals.
NOTE:
For accurate readings be sure Ignition Switch is
OFF when tractor is not in operation.
Malfunction Indicator Light (EFI models only)
The malfunction indicator light flashes
when there is a problem with the
electronic fuel injection system. When
indicator light flashes, disengage PTO,
shut off engine, remove key and see engine manual.
Axle Locks
For a solid front axle, install axle locks on front axle. For a
pivoting front axle, remove axle locks from front axle and
store on unit.
Headlights
Push headlight switch to ON position to turn ON
headlights. Push headlight switch to OFF position to turn
OFF headlights.
FILLING FUEL TANK
Add fuel to Fuel Tank as needed. See your Engine
Manual for correct type and grade of fuel.
To add fuel to the fuel tank:
1. Place unit in an open or well-ventilated open area.
2. Stop the engine.
3. Clean the fuel cap and the area around the fuel cap
to prevent dirt from entering the fuel tank. Remove
the cap from the fuel tank.
4. Fill the fuel tank to within 1" (25 mm) below bottom
of filler neck.
5. Replace fuel cap and tighten.
6. Clean up any spilled fuel.
WARNING:
Make all seat adjustments with unit
stationary, parking brake engaged and engine
shut off.
OF1700
RIGHT
TANK
LEFT
TANK
OFF
OF1881
OF1740
WARNING:
AVOID INJURY. Read and
understand entire
Safety
section before
proceeding.
OG0601
OD0190
