EN - 24
Clean Battery
1. Clean terminals and battery cable ends
with a wire brush.
2. Coat terminals with dielectric grease or
petroleum jelly.
Install Battery
1. Reinstall battery.
2. Reconnect positive cable and then the
negative cable.
3. Place boot over positive terminal.
4. Reinstall battery bracket and battery
cover and secure with two wing knobs.
CHARGE BATTERY
Check battery with a voltmeter. If battery is
less than 11 volts, charge battery.
NOTICE:
DO NOT fast charge. Charging at a
higher rate damages or destroys battery.
ONLY use an automatic charger designed for
use with your battery.
NOTICE:
Always follow information provided
on battery by battery manufacturer. Contact
battery manufacturer for details regarding
charging.
1. Remove battery from unit. See
2. Place battery on bench in a well-
ventilated area.
3. Connect positive lead of charger to
positive terminal.
4. Connect negative lead of charger to
negative terminal.
5. Charge battery following battery
manufacturer’s instructions.
6. Reinstall battery. See
Jump Starting
Gravely does not recommend jump starting
your unit. Jump-starting can damage engine
and system components. Refer to engine
manual for details.
CHECK FASTENERS
Check for loose hardware and tighten if
necessary.
LUBRICATE UNIT
1. Apply oil to all pivot points and pin
connections.
2. Pump grease into grease fittings.
LUBRICATE CASTER HUBS
1. Place unit in service position. See
2. Pump grease into grease zerks until
grease appears at the top of caster hubs.
LUBRICATE CASTER WHEEL
BEARINGS
1. Place unit in service position. See
2. Support unit so front wheels are off the
ground.
3. Remove wheel from fork.
4. Pump grease into grease zerk until
grease passes through the seal in the
wheel hub.
5. Wipe away excess grease.
6. Reinstall wheel into fork and lower unit to
ground.
Figure 26
1. Wing Knob
2. Battery Cover
3. Battery Bracket
Figure 27
