Gravely Pro-Turn 48, Owner'S And Operator'S Manual

Page: 31 / 46

EN - 31
ADJUSTING THE HEIGHT OF THE
STEERING LEVER HANDLES
(Figure 18)
NOTE:
Align handlebars by adjusting
eccentric spacer until the handlebar height is
the same.
1. Remove mounting hardware and move
handlebar up or down until the steering
levers are at the appropriate height.
2. Install mounting hardware.
ADJUSTING THE PARKING
BRAKE
The parking brake should not need
adjustment, however if the parking brake
does not hold the unit properly, the brake may
need adjustment.
Check Adjustment
(Figure 19)
NOTE:
Be sure to check the parking brake on
both sides of the unit.
1. Engage parking brake and set both
transmission bypass valves to the
neutral position. See
Moving the Unit
with the Engine Off
on page 22.
2. Push the unit forward.
If the unit easily rolls forward the
transmission brakes are not fully
engaging. Tighten the brake cable to
fully engage the brake lever on the
transmission.
Adjust the Parking Brake
(Figure 19)
1. Disengage the parking brake.
2. Loosen the nuts on the parking brake
cable adjuster and then turn the adjuster
until the cable is taut, not tight.
3. Engage the parking brake and check the
adjustment. Repeat as needed.
4. Tighten the nuts.
NOTE:
Set both bypass valves to the drive
position when finished adjusting the brake.
PTO BELT
Figure 17
1. Limiter Bolt
2. Jam Nut
3. Steering Lever
4. Stop Bracket
1
2
3
1
4
2
Figure 18
1. Handle
2. Eccentric Spacer
3. Steering Lever
4. Mounting Hardware
1
3
2
4
WARNING:
MOVING PARTS can
cut or amputate body parts.
ALWAYS wait for moving parts to
stop before performing
maintenance or service.
Figure 19
1. Parking Brake Cable
2. Adjuster
3. Nuts
1
2
3