EN - 18
PRE-START
1. Check Safety Interlock System
If this system does not function as described
do not operate until repairs are made.
2. Check Air Cleaner
Check air filter for dirt and overall condition.
Clean as required. Follow engine manual
maintenance schedule.
3. Check Engine Fuel and Crankcase
Oil
Check and add fuel if required. Check that
engine crankcase oil is full. Follow engine
manual maintenance schedule.
4. Check Tire Pressure
See
Specifications
on page 39 for correct tire
pressure.
5. Check Hydraulic Fluid Level
See
Check Hydraulic Fluid Level
on page 24.
6. Set Cutting Height
Make sure the deck is set to the correct
cutting height. See
STARTING AND SHUT OFF
Carburetor
Models 994121, 123, 125, 126, 127, 128,
129
To start engines with a carburetor:
1. Move the steering levers to the neutral
position.
2. Move the PTO switch in the off position.
3. Engage parking brake.
4. If the engine is cold, move the choke
control to the on position. If the engine is
warm or hot, do not use choke.
5. Move the throttle to 3/4 fast position. See
the engine manual for detailed
instructions.
6. Put the ignition key in the switch and turn
it to the Start position.
7. As soon as the engine starts, release the
key.
8. Move the choke control to the off position
from the Choke position. Wait until the
engine is running smoothly before
operation.
To stop the engine:
1. Bring the steering levers to neutral.
Disengage the PTO and engage the
parking brake.
2. Move the throttle lever to the slow
position.
3. Turn the ignition key to the off position.
Electronic Fuel Injection
Models 994124, 130
To start engines with fuel injection:
1. Move the steering levers to the neutral
position.
2. Move the PTO switch to the off position.
3. Engage parking brake.
4. Place the throttle control halfway between
the slow and fast positions.
5. Insert the ignition key in the switch and
turn the key switch to the on position for
one minute. This allows the fuel pump to
cycle and prime the system.
6. Turn the key switch off.
7. Turn the key switch to the Start position,
crank and start engine.
If the engine fails to start, repeat
steps 5 and 6.
8. As soon as the engine starts, release the
key.
9. If the engine does not start after two
priming intervals, contact your Dealer for
further assistance.
IMPORTANT:
Do not crank the engine
continuously for more than 10 seconds at a
time. If the engine does not start, allow a 60-
second cool down period between starting
attempts.
To stop the engine:
1. Bring the steering levers to neutral.
Disengage the PTO and engage the
parking brake.
2. Move the throttle lever to the slow
position.
3. Turn the ignition key to the off position.
CAUTION:
Make sure all hardware
is tight, all safety devices are in
place and all adjustments are
made correctly.
CAUTION:
Read entire
Owner/Operator and Engine
Manual first. DO NOT attempt to
start engine at this time.
Summary of Contents for Pro-Stance 48
Page 45: ......
