Gravely Compact-Pro 34, Operator'S Manual, Page: 30 / 42

EN - 28
4. Reinstall clutch stop bracket and secure
with original hardware. See Figure 39.
5. Reinstall clutch wire.
6. Reinstall PTO belt. See Install PTO Belt
on page 26.
REVERSE CLUTCH BRAKE
PLATES
See Figure 40.
1. Remove and retain hardware securing
brake plates to clutch bracket.
2. Reverse the brake plates and secure to
clutch bracket using original hardware.
ADJUST ANTI-SCALP WHEELS
Model 991145
See Figure 41.
The anti-scalp wheels are set at the factory
for typical mowing height, but can be adjusted
for high or low cutting conditions. Make sure
all wheels are set to the same height.
1. Place unit in service position. See
Service Position on page 16.
2. Remove hardware securing anti-scalp
wheels to deck and remove wheels.
3. Position wheels as necessary:
• For a very high cutting height, set the
anti-scalp wheels in the lowest position
on the bracket.
• For a very low cutting height, set the
anti-scalp wheels in the highest position
on the bracket.
4. Secure with original hardware.
IMPORTANT: All anti-scalp wheels MUST be
set to the same height.
ADJUST PARKING BRAKE
LEVER
1. Place unit in service position. See
Service Position on page 16.
To access brake cable:
2. Chock front wheels and support unit so
both drive wheels are off the ground.
3. Remove and retain lug nuts from wheel
hub. See Figure 42.
4. Remove drive wheels.
Figure 39
Figure 40
Figure 41
Figure 42