Assembly of the rig
Note: The rig of your Micro Magic RTR is designed so that it can be replaced by another /
smaller one if necessary for use in competition, without requiring nodes must be opened.
Slide the boom bearing on the mast so that the aluminum press-down is on top. Take the lon-
ger cord, with a prepared sliding clamp and run the free end of the bottom through the plastic
tubes on boom fitting. Loosen both screws on the mast plate, insert the mast with the fitting
completely into the hull, so that the two lugs engage the boom bearings in the recesses of the
mast and the mast plate rests on the hull bottom. Tilt the mast until it stops backwards and
screw the mast plate firmly back.
Attach the masthead already ailing backstay at the rear by putting and move the loop over
the round fitting the clamping slide so that the stay is slightly stretched, without bending the
mast. Attach both shrouds (mast bracing to the side) and keep here also very little tension.
Important: The opening of the staples must be facing aft. Twist the eyelets if necessary.
Otherwise, the jib sheet could be caught in sailing, which would make the boat nearly unma-
nageable and it might be a threat to the sail servo.
