GRAUPNER GmbH & Co. KG D-73230 KIRCHHEIM/TECK GERMANY
No liability for printing errors. Technical modifications reserved.
09/2011
8
•
Use the RC system transmitter to adjust the sail
setting lever to the “sails fully close-hauled” position.
Run the main sheet over the return clamp bracket, set
the sail central, and secure the sheet with the annular
clamp. If you do not need or wish to de-rig the model
for transport, we recommend that you route the sheet
through the holes in the sleeve, in a similar way to the
forestay, and then secure it with a knot (also applies
to the jib).
•
Run the jib sheet through the hole in the end of the jib
boom, and secure it with the annular clamps. With the
mainsail fully close-hauled, set the jib to the “run out
slightly” position (approx. 5°).
•
Carry out a check of the radio controlled functions.
Note that the jib trim only has a very small range; this
is intentional, and is sufficient for the trim function.
•
By default the jib trim and the rudder control are as-
signed to the right-hand stick unit, with sail control on
the left-hand stick. If you wish to change this arrange-
ment, you will need to re-connect the servo leads at
the receiver.
•
Install new dry cells, or fully charged rechargeable
cells, and check that everything works according to
your wishes. You can now place the canopy on the
cockpit, secure it with the latches, and launch the boat for its maiden run.
Note: all the injection-moulded components used on the model are original Graupner parts as used on the
racing MICRO MAGIC (Order No. 2014), so you can use these parts for any modifications or re-rigging of the
model; the same applies to the polyester cord (Order No. 674).
