GRAUPNER HoTT MC-16 Series, Programming Manual

Page: 79 / 332

79 Program description - Model select
Model select
Call up model 1 … 20 (
mc-16
) or 1 … 24 (
mc-20
)
This option is available as standard on
both transmitter types.
The basic operation of the transmitters
keys was explained on pages 28 and
29 and, on the previous double-page, explanations
were provided for navigating to the multi-function list
and about how to make allocations for a new model
memory. At this point we now wish to begin with the
“normal” description of individual menu items in the
sequence they are arranged in the transmitter. There-
fore we will begin with the menu …
Model select
Copy / Erase
Suppress menus
Suppress models
Model select
Base setup model
Model type
Copy / Erase
Suppress menus
Suppress models
Model select
Base setup model
Helicopter type
As many as 20 respectively 24 complete model set-
tings, including digital trim values for the trim buttons,
can be stored. Trimming is stored automatically such
that a switchover from one model to another does not
cause a loss of current trim settings. To the right of
the model number, each occupied model memory line
in this display shows a pictograph of the model type
as well as the model’s name entered for the model
in its »Basic settings, model« menu, page 86 or
94. The code, if present, for the receiver “bound”
to the model memory location will appear in right the
line.
Select the »Model select« menu with the selection
keys of the left or right four-way button then briefly tap
on the
SET key of the right four-way button.
Attention!
Switch-OFF
the Receiver first!
If this message appears, there is a telemetry connec-
tion to an operationally ready receiver system. Switch
that receiver system off:
01
03
04
05
ULTIMATE 02
GRAUBELE
STARLET
BELL47G
06
R12
R12
R12
–––

free


free

Now, with the

selection keys of the left or right
four-way button, select the desired model memory
from the list and activate it with a tap on the
SET key.
A tap on the ESC key will cause a return to the previ-
ous menu page without activating a model change.
Notes:
• If, after a model change, the “Throttle too high”
warning appears, the throttle/pitch stick (C1) or the
throttle limiter – by default, the right-side propor-
tional rotary slider – is too far in the full throttle di-
rection.
• If a model change causes the message …
T h r
t o o
h i g h !
… to appear, then the throttle / collective pitch
stick (Ch1) or the throttle limiter – by default the
right-hand side-mounted proportional rotary slid-
er – is too far in the direction of full-throttle.
• If a model change causes the message …
BIND. N/A
OK
… to appear then binding settings should be
checked.
• If a model change causes the message …
F a i l S a f e
s e t u p
t . b . d .
… to appear then respective fail safe settings
should be checked.
• If battery voltage is too low, the model switchover
cannot be made due to reasons of safety. An ap-
propriate message will appear in the screen:
n o t p o s s i b l e n o w
v o l t a g e t o o l o w
mc
 
16 20