33610 General Engine-Module - Graupner HoTT 2.4
16
9. TELEMETRY DISPLAY
If you select SIMPLE DATAVIEW the telemetry data can only be displayed, i.e. it cannot be programmed - in
contrast to SETTING AND DATAVIEW. However, the data is represented in graphic form, and this makes it
the preferable option when actually operating a model, as it is easier and quicker to read and assess.
You should also read the manual of your remote control system, especially the chapter „telemetry“. The
operation is done in the transmitter menu „telemetry“ under the display SETTING & DATA VIEW.
Please note
: the menus can only be selected when the receiver is switched on. When you switch the recei-
ver on, it may take a few seconds before the receiver display becomes active and can be selected: > symbol
appears at the top right corner of the transmitter display (TX). When the receiver is off, the error message
„Can‘t receive data“ appears.
There may be a slight delay in the screen’s response to inputs using the top buttons, since all the settings
are transmitted directly to the receiver by wireless means.
Operation with the SMART-BOX:
Switch the transmitter on: the start screen of the SMART-BOX displays SETTING AND DATAVIEW / MODEL
SELECT. Use the INC or DEC button to move the arrow cursor to MODEL SELECT, then press ENTER to
switch to the graphic representation of the telemetry display.
Please note:
these menus can only be selected if the receiver is already switched on. After you switch the
receiver on, note that it may take several seconds before the display becomes active, and can be selected.
There may be a slight delay in the screen’s response to inputs using the top buttons, since all the settings
are transmitted directly to the receiver by wireless means.
Once you have selected MODEL SELECT, the Smart-Box displays the telemetry menu. You must then select
the appropriate sensor using the arrow cursor, depending on whether you are operating a model aircraft
(AIRPLANE) or a model car (CAR).
It is possible to select any of the displays, but - as you would expect - the unit can only display those parame-
ters for which sensors are actually installed in the model; all the other parameters display the value 0.
Use the INC (
) or DEC (
) button to move the arrow cursor to AIRPLANE (model aircraft) or CAR (model
car), then press ENTER (
SET
) to move to the corresponding telemetry display.
In the aircraft display (AIRPLANE) you can use the INC or DEC button to select one of the following graphic
displays:
RECEIVER:
shows the same data as RX DATAVIEW
RE GENERAL MODULE:
+ two additional sensors. As RX DATAVIEW, As RX DATAVIEW, but
plus rotational speed (RPM), altitude (ALT), current
The right third of the display is shown alternately.
0.0V
BATT1
BATT2
0.0V T2 +20°C
T1 +20°C
E FUEL F
ALT
+500m
0m
|s
0m
3s
POWER-V
25.3A
12.5V
80.0
Ah
m
0.0V
BATT1
BATT2
0.0V T2 +20°C
T1 +20°C
E FUEL F
CELL.V
1:0.00
2:0.00
3:0.00
4:0.00
5:0.00
6:0.00
12500
