16 - 20
48325_jh_V1
Trouble shooting
If you cannot resolve your problem with the help of the following
notes, please feel free to contact our service centre.
OBSERVATION
POSSIBLE CAUSE / SOLUTION
No image, display is completely dark.
- No power supplied. Check power
connections.
No image, display is glowing dark grey.
- If using wireless module, turn on RX power
on bottom of headset.
- If using AV in cable, check video source.
- Ensure TX is on and camera connections
solid
- Ensure lens cap is removed from camera
- Trying to power a 12V camera with the 5V
TX supply (need to connect 12V camera
direct to RC pack.
Complete white screen
LCD driver has failed and needs to be repla-
ced under warranty. Contact your retailer.
Lots of interference lines (horizontal lines)
- Choose a cleaner channel.
Lots of interference lines (horizontal lines)
when using 5.8Ghz receiver.
- Ensure headset is turned on before RC
radio
- Review controller manual for correct set-
tings
- Check servos are plugged into correspon-
dingly selected channels
Head tracker not working but can hear beeps
(can enter and navigate beep menu)
- Check to see if cause is harmonic interfe-
rence from
2.4Ghz RC controller (turn radio on/off).
- Use CH1 on TX/headset (Ch1 not affected
by 2.4Ghz)
- check correct frequency antenna is used
Head tracker not working, and no beeps (can’t
enter nor navigate beep menu)
- Cable was modified and resulted in voltage
applied to signal line (fried HT)
- Mated to an aftermarket channel mixer
and wired wrong resulting in voltage applied
to signal line
- Incorrect installation of aftermarket UHF
RC system resulting in voltage applied to
signal line .
Head tracker stops working after short time
Auto disengage function activated. Follow
menu instructions to turn off.
Short range
- Ensure 5.8Ghz antenna were installed
- Turn off transmitter and check for other
sources of interference
- Ensure transmitter has clear LOS to head-
set. Test in wide open area, away from any
obstructions
Short range (con‘t)
- Ensure that a compatible antenna is instal-
led. Do not use other manufacture antenna,
they may be dual band or may be reverse
SMA (no center pin to connect to receiver)
White dots on LCD display
Goggles lens were left exposed to sun
allowing magnified
sunlight to burn off LCD color filter.
Summary of Contents for Fatshark Attitude V2
Page 1: ...Manual Fatshark Attitude V2 CE goggles No 48325 EN...
Page 2: ...2 20 48325_jh_V1...
Page 19: ...19 20 48325_jh_V1 Notice...
Page 20: ...20 20 48325_jh_V1...
