GRAUPNER GmbH & Co. KG D-73230 KIRCHHEIM/TECK GERMANY
Modifications reserved. No liability for printing errors. Id.-Nr. 0062273 3/2011
-
4
-
shown in the photo. Tighten the nuts just to the point where the swivel pushrod
connectors rotate smoothly, but without lost motion.
Screw the servo output arms to the servos in the arrangement shown in the picture.
Fix the rudder servo in the right-hand fuselage shell (1) with a single drop of cyano on
each mounting lug and one on the underside of the servo case.
Caution: do not use thin cyano to secure the servos, or too much cyano of any
type, as it could penetrate the case and jam the moving parts.
Use the same procedure to glue the elevator servo in the left-hand fuselage shell (2).
Check from the transmitter that both servos still work correctly.
Fix the motor (10) to the motor mount (8) using the two screws (9). Tighten the
screws fully, and secure each one with a drop of cyano.
The motor mount (8) can now be glued in the right-hand fuselage shell. Press the
cables into the channel, and secure them with a little glue. If necessary, shorten the
motor cables by deploying them in a curve - as shown in the photo - so that the
BRUSHLESS CONTROL 18 speed controller lies flat on the fuselage. Tack the
speed controller in place with a little adhesive.
