55
the horizontal position between the cursors, and simultaneously the horizontal and
vertical coordinates of the current located point, and the horizontal and vertical
increments between the two cursors are displayed. The horizontal coordinate is
displayed as a time value, and the vertical coordinate is displayed as a voltage value,
as shown in figure 2-53.
Figure 2-53 Measurement result
The operation steps are as follows:
1. Press
[CURSORS]
to skip to the
“CURSOR”
menu.
2. Select
“Cursor mode”
as
“Tracking”
.
3. Press
“Cursor A”
, and select the input channel CH1 or CH2 of the tracked signal.
4. Press
“Cursor B”
, and select the input channel CH1 or CH2 of the tracked signal.
5. Select
“Cur A”
, and rotate the [UNIVERSAL] knob to horizontally move cursor A.
6. Select
“Cur B”
, and rotate the [UNIVERSAL] knob to horizontally move cursor B.
7. Display the measured values on the left upper corner of the screen:
A
→
T :
Position (namely the time based on the horizontal central position) of cursor A
in the horizontal direction.
A
→
V :
Position (namely the voltage based on the grounded point of the channel) of
cursor A in the vertical direction.
B
→
T :
Position (namely the time based on the horizontal central position) of cursor B
in the horizontal direction.
B
→
V :
Position (namely the voltage based on the grounded point of the channel) of
cursor B in the vertical direction.
Delta T :
Horizontal distance (namely the time value between the two cursors) of
cursor A and cursor B.
