Step 3; See Figure 3:
Install and adjust Frame
A.
Insert the Bracket into the Receivers and tighten the receiver bolts. Hold the frame level and
tighten the Bracket to frame bolts. Insert the hand knobs into the weld nut on the receivers and
tighten.
Figure 3
Step 4; See Figure 4:
Install Vinyl Cover
A.
Slip the front of the Vinyl Cover over the front bow. Pull the rear of the cover down over the rear
bow. Push the center bow up to tighten the cover if needed.
Figure 4
4
Note:
Place the shims into the clamps as
shown for installation on machines with
1 1/2” x 1 1/2” square tube ROPS.
