GRASS VALLEY TRINIX NXT -, Installation Manual

Page: 329 / 449

Trinix NXT — Installation and Service Manual 329
Section
14
Broadlinx Console Commands
The following commands can be used when you are connected to the Trinix
NR-33000 (Broadlinx) board through a console session on a PC using either
a serial connection to the Console A port or an Ethernet/ Telnet connection.
Each of these commands is explained in the tables below. You can quickly
access the commands by clicking the first letter of the command below.
[ A ] [ C ] [ D ] [ E ] [ F ] [ H ] [ I ] [ L ] [ M ] [ N ] [ O ] [ P ] [ R ] [ S ] [ T ] [ U ] [ V ]
Table 60. A
Command Arguments Detailed Description
addBoards (void) Adds new boards in frames to the system immediately
without rebooting or waiting for the deviceMaster inac-
tive frame time.
Table 61. C
Command Arguments Detailed Description
cmActivateShow (int archiveNo, int verbose) No Help Text (rl_codeManager.cc)
cmUpdate (int who) Determine which components to update when activat-
ing.
Normally this would be left 0xf to update everything. It
can be changed for testing.
codeManagerDump (int verbose) Debug function used to dump the contents of the struc-
tures in CodeManager (since the debugger doesn't
seem to handle them very well).
Setting verbose to 0 dumps a safe version (that is, no
assumptions about pointer validity).
If verbose is true, then it assumes the pointers are valid
and tries to dump additional information about the
classes pointed to by the pointers.
codeManagerDumpArchive (int archiveNo) Debug function used to dump the contents of the Code-
Manager's archives.
codeManagerLoadFile (char *fileName, int
archiveNo, bool active) Loads a code file.
codeManagerShow (int verbose) Show the function for CodeManager class.
codeManagerShowProgress (int verbose) Show the progress of activate archive.
comBusShow () Samples the com bus and reports what devices have to
say.