GRASS VALLEY NV9680, User Manual

Page: 42 / 49

26
Misc. Topics
Power Cord Retention
Power Cord Retention
Use the supplied retention strap to keep the AC power cord firmly connected to the power
supply. Follow these steps to use the strap:
1 Firmly insert the AC power cord into the power supply. Examine the last figure in this
section to see how the strap should be applied.
2 Placed the Velcro retention strap, fuzzy side up, on top of the power supply with the
buckle loop approximately 1 inch from the AC input side and the remaining strap
around the cord end and down:
3 Holding the buckle in place, lift the strap up and around the cord end so the strap
overlaps itself:
4 Holding the buckle loop in place, route the strap around the back of the supply
diagonally across so that it sticks out on the left below the output cord:
5 Continue the strap around toward the buckle loop and through the loop. Cinch the
strap tightly. While keeping tension, place the 2 inch strap end (with Velcro loops)
down on the fuzzy part to complete the process:
6 Examine the strap though its path around the cord and power supply. Be sure that no
slack exists and that it is tight the full length of the strap. If necessary, adjust and cinch
it more tightly.