GRASS VALLEY NV9649, User Manual

Page: 121 / 167

111
NV9649
User’s Guide
Selecting a source activates the ‘Take’ button, which you must press to complete the route.
Source Mode
The button places the panel in source mode. Category selections in source mode select
source devices. Category buttons that are not source categories become disabled in source
mode.
Categories that include both source and destinations appear in both source mode and
destination mode.
In source mode, a category selection appears at the beginning of the ‘Preset’ display.
Src/Dst Mode
The button toggles between source and destination modes. Category selections in source
mode select source devices. Category selections in destination mode select destination
devices.
Source is Master
Means “source is the master” and makes the source device the master. Otherwise, the
destination is the master. This button (and these concepts) apply only to machine control
routes.
The button is a toggle: Press it once to make the source the master (it goes high-tally); press
it again to make the destination the master (the button is low-tally).
The ‘Source is Master’ button is also used to initiate “broadcast” machine control routes.
See
Broadcast Routes , on page 90.
During data level (i.e., machine control) takes, this button makes the source device the
master. Otherwise, the destination is the master.
The button is a toggle that reverses the direction of data routing. For example, if the
destination is the master and the source is the slave, pressing a ‘Source is Master’ button
reverses their roles. Pressing the button again reverses the roles.
The ‘Source is Master’ button is used to initiate “broadcast” control routes. See Broadcast
Routes , on page 90.
The panel can be configured so that “source is master” is the default state or so that
“destination is master” is the default. The button still toggles between “source is master”
and “destination is master.”

Pressing the ‘Source is Master’ button turns off the ‘Broadcast’ button and vice versa.
Take
In normal mode, a take button routes the preset source to the selected destination on
selected level or levels.
In salvo mode, a take button executes a selected salvo.
A take button is disabled (and dark) until it becomes possible for the operator to execute a
take.