12
Setting Up the Kaleido-IP
Networking Setup
11 Under
Date and Time
, select the appropriate time zone and format for your location.
12 If this Kaleido-IP is meant to monitor HLS sources, enable NTP synchronization: next to
NTP synchronization
, click
Enabled
, and then type the NTP server’s IP address.
13 Click
Save
.
The new settings are saved locally.
14 Click
OK
.
15 The
Apply settings
button becomes available.
16 Click
Apply settings
.
The multiviewer must be restarted for changes to the network configuration to take
effect. A message appears prompting you to reboot the system immediately.
Network mask
Must be set to the appropriate values, for the management and data
networks.
Default gateway
If your management network is not configured with a gateway, clear
the default gateway IP address.
Detected link mode By default, all network adapters are set to auto-negotiate. The
connection speed and duplex mode will be set automatically based
on the corresponding port settings on the associated switch.
Configured link
mode
1000 Mbps full-duplex
communication can only be achieved via
auto-negotiation, as required by the IEEE-802.3 standard, section
28D.5. Should your network configuration require specific speed
and duplex mode settings, select the appropriate value from the
Configured link mode
list.
Summary of Contents for Kaleido-IP X110
Page 1: ...Quick Start Guide M926 9405 104 17 December 2014 ...
Page 12: ......
Page 16: ......
Page 44: ......