GRASS VALLEY JUPITER CONTROL PANEL L32 -, Instruction Manual

Page: 65 / 216

JUPITER L-S and LCD Series Control Panel Instruction Manual 65
Compiling
3. Enter the number of the desired button in the Button Assignment
column. For example,:
• Buttons 1-32 for the L32 panel.
• Buttons 1-64 for the L64 panel.
• Buttons 1-100 for the S100 panel.
Apply the changes by recompiling the set. The associated button will then
be disabled.
Note An output called BLANK can be added to the Switcher Output table, without
assigning a physical output. This addition allows the BLANK output to be
selected in the control panel set.
Compiling
Before the panel(s) can be operated, the edited Jupiter set must be compiled
and the appropriate configuration set made active using the Control
Center. For more information, refer to the
Jupiter CM-4000 Installation and
Operation Manua l.
Following this step, the CM-4000/AccuSwitch control system should start
communicating with the panel(s); i.e., the panel(s) will indicate some form
of router status.