GRASS VALLEY JUPITER CONTROL PANEL L32 -, Instruction Manual

Page: 102 / 216

102 JUPITER L-S and LCD Series Control Panel Instruction Manual
Section 6 — L-S Series Panel Operation
Clearing Panel Modes
L32 and L64 panels can be placed into various modes for item and menu
selection. Buttons on the panel behave differently, depending on what
panel mode is currently active.
If a
Level
or
Preset
button is lit, pressing it will clear that panel operating
mode.
Pressing the
Clear
button exits the panel from some menu display and selec-
tion states.
In the completely cleared home state, Sources can be switched to Destina-
tions using the panel buttons.
Destination and Source Selection Methods
On L32 and L64 panels Destinations and Sources can be selected directly,
by pressing buttons on the panel, or by scrolling through menus.
Direct Selection - This is the fastest method for selecting a Source or Destina-
tion, but is limited to the number of buttons configured on the panel.
Menu Selection - This method requires more steps, but allows selection of
Sources or Destinations not currently assigned to buttons on the panel.
Note If a Source or Destination cannot be selected, the panel may be restricted by
the CP Input or CP Output set used on the MPK Devices table. See
Section 4-Jupiter System Configuration .
Selecting a Destination to be Controlled
The Destination window displays the name of the Destination currently
being controlled in yellow.
Direct Selection Method
Buttons configured for Destinations that are not currently being controlled
by the panel are illuminated in low yellow.
1. Clear the panel (
Level
,
Menu
, and
Preset
buttons OFF).
2. Press the preferred yellow Destination button. If the selection is valid,
the button will illuminate in high yellow. The name of the Destination
will appear in the Destination window, and the name of the Source
currently switched to that Destination will appear in the Status
window.
You will now be able to select a different Source for that Destination.