GRASS VALLEY IQUCP25, User Manual

Page: 77 / 338

77
UCP - 3901
User Manual
Setting Spigot Configuration
To set a new spigot configuration, follow these steps:
1 From the
Configuration
page, select the required software from the
Software Version
pane, then select the firmware which provides the required combination of inputs,
outputs and flow standards from the list displayed on the Card Firmware > New pane.
Note that Restore and Restart buttons are displayed only when an item not currently
installed is selected.
2 Enable the Reset to Defaults on Restart checkbox. This will cause existing details
stored on the module, other than network IP settings, to be cleared down prior to
restarting the module. See Defaults on page 164 for more information.
3 Click
Restart
to restart the module and implement any changes made.
IMPORTANT!
Existing details must be cleared down before establishing a new
configuration . Failure to do this may result in unexpected behavior
from the module.