GRASS VALLEY IQUCP25, User Manual

Page: 255 / 338

255
UCP - 3901
User Manual
1 Open the UCP - 3901 templates with RollCall Control Panel on port 2051. See
Connecting to the Multiviewer SDC with RollCall for UCP - 3901 Card , on page 62.
2 In the
System-Setup
template, configure settings as shown below.
3 In the
Layout
template:
• Select Identify Inputs ; and
• Select Identify Outputs .
This will add an overlay onto the head display inputs and outputs, to help identify head
display outputs (1 to 4) and the video inputs (1 to 12) as they are numbered. This is
useful during initial set up of a module. The overlays can be turned off later without a
system restart being required.
4 Return to the System-Setup template. Click System Reset and then click Confirm .
The module restarts for all the settings changes to take effect. Wait for the module to
complete its restart (approximately 75 seconds).
STEP 2: UCP - 3901 Media Interface(s) Setup (Video IP Streams)
After the rear SFP-1 and SFP-2 Ethernet interfaces are set up in STEP 1: Preliminary
Multiviewer SDC Configuration , on page 253, the various spigots of the UCP - 3901 need
configuring for:
• Sending Spigots 1 to 4. These are the source spigots - these transmit multiviewer head
display output video IP streams.
Setting Action
RollCall Settings /
RollCall Network
Select the RollCall network to use.
RollCall Settings /
RollCall Unit
Select the RollCall unit number to use.
RollCall Settings /
Domain ID
Specify the RollCall Domain ID to use.
Output Format /
Selection
Select the required multiviewer head display output video format.
Information If required, enter a name, location, and/or notes about the module.
This may be done at a later time.