GRASS VALLEY IQUCP25, User Manual

Page: 253 / 338

253
UCP - 3901
User Manual
Default Multiviewer SDC Video Wall
The Multiviewer SDC is shipped with a default Orbit multiviewer project. Its video wall
layout displays all multiviewer video inputs. This is shown in Figure 8-2.
Fig. 8-2: Default Project - Typical Multiviewer Head Display Output showing video inputs 1 to 12
The same layout is repeated across the four head display outputs (Output 1, Output 2,
Output 3, Output 4) with the same wall layout.
STEP 1: Preliminary Multiviewer SDC Configuration
To enable the Multiviewer SDC to be fully hosted in a system, ready for further
configuration, some preliminary settings need to be set up. This section configures some
preliminary settings through RollCall templates.
Configuration items include:
• Basic configuration of the media Ethernet interfaces.
• Video reference selection.
• RollCall settings, including domain.
• Multiviewer head display output video standard selection.
STEP 1.1: Preliminaries - UCP - 3901 Templates
This sub-section uses the MANAGEMENT / IQ modular chassis Ethernet interface to access
the UCP - 3901 Card’s RollCall templates.
1 Open the UCP - 3901 templates with RollCall Control Panel on the default port 2050. See
Connecting to the Multiviewer SDC with RollCall for UCP - 3901 Card , on page 62.
Note:
Re-sizing a video input tile on one output will re-size it on the other
outputs because each video input has one scaler.
Resizing does not affect the tile layout. The result is scaled video anchored in
the top-left of the current layout. That is, it is only the content that is scaled;
the layout is unaffected (so any graphics overlay will not change).