GRASS VALLEY IQUCP25, User Manual

Page: 216 / 338

216
MADI Processing SDC
Logging Pages
Logging Pages
All alarms and operational statuses can be seen from Rollcall Logging pages. These pages
provide the live status of the card. Theses statuses are also logged when using a Log Server.
For a UCP - 3901, the Log Server is set in the screen below.
Log fields are always prefixed with WARN: , OK , or FAIL: .
Logging - Configuration (UCP - 3901 Only)
The Logging Configuration page sets the destination logging server, if required.
Figure 7 - 18: Logging Configuration Page
Parameter Description
Logging Set the connection type to the log server.
Named LogServer:
Specify the specific name of the log server to use
for logging.
Any LogServer:
Logging is sent to any LogServer that is discovered
on the network.
Logging Disabled:
No logging is generated.
Logging Interface Set the network interface that has network connectivity to the log
server.
1G: The Gb management Ethernet network. This option is not to be
used with IQUCP25 cards.
Ethernet 1: The Ethernet network connected to SFP 1.
Ethernet 2:
The Ethernet network connected to SFP 2.
For the location of the card’s Ethernet ports, see Rear Panel and
Connectors on page 32.
Log Server Name When
Logging
is set to
Named LogServer
, this sets the name of the
log server to use for logging.
Current Log
Server
Shows the name of the current log server being used for logging.
Current Log
Server Address
The current Rollcall log server’s IP address.