118
Concerto — Instruction Manual
Section 3 — Control System Configuration
AES Attributes
This section contains information for the AES Attributes as they are config-
ured using an SMS7000 GUI. Encore settings are slightly different but the
fundamental principles are the same.
The
Output Attrib Info
and
Input Attrib Info
buttons are enabled when there is a
check in the
AES Attributes
box. Some of these attributes require Concerto-
specific settings.
AES Output Attributes
1.
Click the
Output Attrib Info
button to access the settings for output
attributes. Use this dialog to set the outputs individually or in groups.
Note
Asynchronous Output
(or input) is not supported by Concerto.
Figure 70. AES Output Attributes Dialog
Outputs can be assigned
Soft Mute/No Soft Mute
individually, in groups, or
by using the
All
buttons. The
Soft Mute/No Soft Mute
attribute is a soft mute
or alignment of one signal’s amplitude to another signal’s amplitude at
switching. Some users call this audio dunking. Soft mute prevents a
crack or pop at switching.
Note
The 20/24 Bit attribute is not supported by Concertos controlled by
SMS7000.
2.
When you’ve finished assigning Output attributes click
Ok
to finalize
your settings.
Summary of Contents for Concerto
