GRASS VALLEY APEX -, Installation And Service Manual

Page: 91 / 132

APEX — Installation and Service Manual 91
CX-34000 Control Crosspoint Board Configuration
Note S34-8 must be set to ON for APEX PLUS systems.
• S1 through S4
• S7 through S10
• S13 through S16
• S19 through S22
• S25 through S28
If S34-8 is
OFF
, REF and V-fade can be set on a board-by-board basis using
the switches listed above.
S28 5-8 Reference/V-fade Settings
These settings will be assigned to all output boards when S34-8 is
ON
. Oth-
erwise, they will apply only to output board zero in chassis zero.
S28 5-6 - AES/Video Reference Selection
These two switches are used to select Video Reference A, Video Reference
B, AES Reference A, or AES Reference B. For switch setting details, please
refer to the CX-34000 drawing in
Figure 38 on page 94 .
For more information about reference settings, see AES / Video Reference
Selections on page 92 .
S28 7-8 - V-fade
To enable V-fade in the Auto mode, set S28-7 and S28-8 both to
OFF
. In this
case, one of the two Video References must be selected on S28 5-6 (as just
described above).
To disable V-fade, set S28-7 to
ON
. In this case, the position of S28-8 doesn’t
matter.
Note Use of V-fade in the Always On mode (S28-7 OFF and S28-8 ON ) is not rec-
ommended.
For more information about V-fade, see
V-fade (Silent Switching) on page 93
.