GRASS VALLEY 8945EDA -, Instruction Manual

Page: 13 / 44

8945EDA/-D — Instruction Manual 13
Installation
Front Module Installation
If you have an 8900NET module (Net Card) in your frame and will be con-
figuring the module remotely with a web browser or the Newton Control
Panel, install it as described in
Front Module Installation on page 15 .
If you do not have an 8900NET (Net Card) module in the GeckoFlex frame
for remote monitoring and configuration, you will need to configure the
module using the local onboard controls before installing it in the frame as
described below.
Local Configuration
Local configuration of either model 8945EDA consists of two DIP switches
(S1 and S2) highlighted in the lower left corner of
Figure 3 . Refer to Table 1
on page 14 for configuring the 8945EDA/-D with the onboard switches.
Figure 3. Configuration Switches on 8945EDA/-D Modules
Local Configuration
Switches S1 and S2