12
Deinstallation of the dust bag is similar to installation, only the sequence of actions is reversed.
It is recommended to empty the bag after it is half filled.
OPERATION / SETTINGS
SWITCHING ON / SWITCHING OFF
The mains voltage must match the voltage on the label of the sander.
Switching on
– press the switch button (
1
) and hold in this position.
Switching off
– release pressure on the switch (
1
).
Locking the switch (continuous operation)
Switching on:
Press the switch button (
●
1
) and hold in this position.
Press the switch lock button (
●
2
)
(
fig. E
).
Release pressure on the switch (
●
1
).
Switching off:
Press and release the switch (
●
1
).
OSCILLATION SPEED CONTROL
Speed of sander oscillation is controlled by turning and setting the control wheel (
7
) (
fig. F
) in desired
position. It allows to adjust the power tool working speed to match characteristics of processed material.
Increase the oscillation speed by turning the wheel (
●
7
) counter-clockwise.
Reduce the oscillation speed by turning the wheel (
●
7
) clockwise.
Choose proper oscillation speed when the sander operates with switch lock button pressed.
Oscillation speed with load may be lower than the speed set with no load.
FINISHING SANDER OPERATION
●
Whole sanding area must rest on the processed surface.
Turn the sander on, apply moderate pressure and move it on the processed material.
●
When finishing polishing, reduce pressure and lift the sander above the processed surface and only then
●
you can switch off the tool.
OPERATION AND MAINTENANCE
Disconnect the tool from power supply network before starting any regulation, maintenance or
repair.
Always keep the sander clean.
●
Remember to always keep the ventilation holes of the tool casing pervious.
●
Never use any caustic agents for cleaning plastic elements.
●
In case of excessive commutator sparking check technical condition of carbon brushes of the motor.
●
REPLACEMENT OF CARBON BRUSHES
Replace immediately worn out (shorter than 5 mm), burnt or cracked motor carbon brushes. Always
replace both brushes at a time.
Summary of Contents for 59G323
