Page 7
4. Operation of
PMR-
10
0
4.1.
Connect external power supply plug to the grounded mains.
4.2.
The display will turn on with the upper line showing time, RPM and tilt angle set earlier (fig.1/
u
)
and the lower line showing current readings of the same parameters (fig.1/
v
).
How to set the necessary parameters.
Use the readings in the upper line of the display, while setting the necessary parameters.
4.3.
Time set (Time hr:min)
With the help of
the
“
p
” and “
q
“ TIME keys (Fig. 1/
w
) set the required working time interval in
hours and minutes (increment - 1 min). If the button is pressed for longer time the speed of
increment becomes bigger.
Note!
If the operation time is not set and the timer indicator shows 0:00, pressing RUN key
(Fig. 1/
z
)
will allow continuous use until the STOP
key (Fig. 1/
{
) is pressed again.
4.4.
Speed set (Speed RPM)
With the help of
the
“
p
” and “
q
“ SPEED keys (Fig. 1/
x
) set the required
rocking
intensity in
revolutions per minute (increment 1 oscill/min). If the button is pressed for longer time the
speed of increment becomes bigger.
4.5.
Tilt angle set (Angle Deg.)
With the help of
the
“
p
” and “
q
“ ANGLE keys (Fig. 1/
y
) set the necessary angle (increment
1º). If the button is pressed for longer time the speed of increment becomes bigger.
Run/Stop
OFF
30
90
10
90
10
SPEED
ANGLE
RUN
STOP
Time
(hr:min)
Speed
(RPM)
Angle
(Deg.)
Fig.1. Control panel
Platform Rocker PMR-100
Operating instructions
Version
1.02
-
April
20
1
3