Installing the food processor
Positioning the food processor
The Food Processor must be mounted on a flat, stable surface that is strong enough to hold the weight
of the machine. It is important to ensure that the machine can be both easily loaded and operated,
and we recommend a bench or table height of 800mm to achieve this.
No matter where you put the Food Processor, you must allow at least as much space as the overall
dimensions indicate. Allowing an additional minimum of 30cm either side of the Food Processor will
make access for cleaning and maintenance easier.
The Food Processor ejects the processed food through the large chute at the front of the machine. Ensure
that there is enough space on the bench or table top to allow a collection container to sit underneath the
chute. Alternatively, and if space is tight, the Food Processor may be positioned with the ejection chute out
over the edge of the bench or table and a container placed in front of the bench and below the chute. This
option is not recommended as there is considerable potential for creating an unsafe and unhygienic mess.
Cleaning and function check
Before you use the food processor we recommend that you wipe down all exposed surfaces with a soft
cloth that has been placed in clean warm water and light detergent and squeezed dry.
This will remove any traces of machine oil, dirt or grit picked up during manufacture or storage.
Before you wipe down the machine, make sure that the power is turned off at the wall
socket/power point.
Once the food processor is clean you can check that it is functioning correctly.
1. Switch on power to the machine from the wall socket/power point.
2. Make sure that the food processor is turned off at the power switch on the
side of the machine.
3. Open the food processor cover by turning the knurled knob (located in front
and to the right of the input feeder) anti-clockwise until it releases.
4. Raise the cover and place the supplied blade disk in food processor.
5. Close the cover and secure it by turning the knurled knob clockwise until it is tight.
6. Turn the food processor on using the power switch on the side of the machine.
Immediately the chopper blade will spin in an anti-clockwise direction.
7. Turn the processor off at the power switch.
