Required
Supplied
4 x Aluminium Frame Section
1 x Ezy Mount
1x Fabric Roll
7-8 x V-Grip
4 x Corner Stakes
1 x Insertion Tool
1 x Fabric Cutter
3 x Screws
to suit Wall
Rubber Mallet
Level
Electric drill
Screw Driver
Don’t have a Rubber Mallet? Use an ordinary hammer and a
rolled up cloth to prevent damage to the frame.
?
1
3
2
Fabric Roll
Insertion tool
Tip: It’s easiest if you insert the V-grip in the order shown above.
Start at the edge of a V-grip length, but in the middle of the frame.
V-Grip
1
2
7
8
3
4
5
6
Stretch fabric over
the back of the frame.
Push the v-grip
through fabric into the
v-channel.
Drive corner stakes into
frame sections using
rubber mallet.
Lay frame
face down
on floor.
Roll out screen surface with
viewing side
facing the
floor.
Start here
not here
Rubber Mallet
Corner Stake
4
5
Insertion Tool
Crease
Excess
Fabric
Fabric Cutter
Screen
Once screen is free of
creases, trim the excess
material with the supplied
fabric cutter.
If creases or ripples have
developed in the screen surface,
don’t panic!
Simply push the insertion tool
into the V-grip channel near the
uneveness, and pull on the excess
material.
This will re-tension the surface.
PUSH
PULL
16 x Tek Screws
4 x Corner Bracket
1. Drive corner stakes into
frame sections
2. Insert angle brackets
3. Secure angle brackets with
supplied tek screws
