2
5
Take out all the parts from the packaging and follow the accessagires guideline to ensure you have all parts.
There are three installation measures for this product, namely wall mounting, ceiling mounting and ceiling hang. The
installed distance can be changeable up to your needs via adjusting the slipper block, while the ideal position is the
mounting bracket is at its nearest point to the endcap, which can reduce unnecessary vibration or noise.
Installation
1. Choose screws for mounting according to wall material. ( Tips: Wood screws for wood wall, and Tapping screws
for concrete wall.)
2. Mount the brackets onto the wall, assuring they are at the horizontal level. (Tips: draw an erasable level line when
mounting the brackets) (Figure 1) Here below are the details:
Figure 1
Installation Steps
a) Wood wall and ceil ing installati on: Drill in the 5 x 40 screws through the appropriate holes in the bracket
( Figure 2-3 ).
b) Drywall and ceiling and installation: Install the anchors and drill in the 5 x 40
( Figure 4-5).
screws into the appropriate
bracket holes.
Wood wall installation
Wood ceiling installation
Concrete wall installation
Concrete ceiling installation
Figure 2
Figure 3
Figure 4
Figure 5
Floating wall bracket nstallation
i
Instructions
To avoid overheating the motor, do not continually retract and lower the screen for over 4 minutes at a time. If the
motor overheats, it will need a cool down time of 2 minutes. The motor does not need any lubricants. The drop and
retract limit of the screen is factory preset to an optimal configuration. Please ask your local dealer or professional
to adjust settings to avoid damaging the motor.
Motor adjusting slot
Picture 1
Picture 2
Picture 3
2. Automatic remote control (Please see section on Remote Control)
Grandview projection screens are controlled by a manual switch or an automatic remote control.
1. Manual switch control
a.T
b.Connect to a power source (Please make sure it is the right voltage)
c.
; it will come down slowly. When it is all the way down, it will stop
automatically.
d.Turn the switch to
1 to
the screen; it will go up into the metal casing. When it is all the way up, it will
stop automatically.
e.To stop any time while the screen is in motion, turn the switch to 0.
ear off the glue cloth fixed on the bottom rod,ensure the bottom rod is not stuck by the casing.
Turn the switch to position 2 to lower the screen
position
lower
