Copyright © 2015 cloudippbx.com.
7
Primary SIP Server : Enter
VoIP server
.
Outbound Proxy : Enter
VoIP server
.
NAT Traversal : Select
keep-‐alive
.
SIP User ID
：
Enter Unique
(10 numeric characters)
AuthenDcate ID
：
Enter Unique
(10 numeric characters)
AuthenDcate Password
：
Enter
device password
.
Name
：
Enter Unique
(10 numeric characters)
Local SIP Port: any Port number
in range of 50000~60000
*Please allocate different port number to each devices without overlapping.
Ex.) Device A : 50000, Device B : 500001
Check SIP User ID for Incoming INVITE : [
Yes
]
*It will be blocked unauthorized access to the devices.
Preferred DTMF method
：
Supply Priority 1, 2 and 3 with the same informaDon as below:
Priority 1
：
RFC2833
Priority 2
：
In-‐audio
Priority 3
：
SIP INFO
*Set [in-‐audio] as Priority 1 in case [DTMF inband] are set on Unique Management Page.
Disable Call-‐WaiDng
：
・
SelecDng
Yes
will noDfy new caller that line is busy when the callee is sDll at the middle of the call.
・
SelecDng
No
will noDfy new caller to assume that the line is ringing/acDve even when the callee is at the middle of
a call.
※
This is an opDonal seeng. No seeng required if no need.
※
Default is [
No
]. Factory seeng by the company : [Yes]
SUBSCRIBE for MWI : Select [
Yes, send periodical SUBSCRIBE for Message WaiDng IndicaDon
]
Caller ID Scheme
：
Set using the example below.
・
NTT Japan
：
Select when connecDng to a phone device that supports number display
※
It is important to set phone that supports number display. Please refer to the device’s instrucDon manual for the
setup method.
・
Bellcore/Telcordia
：
Select this when using phone other than NTT Japan.
※
The prescribed value is Bellcore/Telcordia. The default factory seeng is
NTT Japan
. If the device does not support
number display, change the seeng to
Bellcore/Telcordia
.
Once done, click Update and Apply respecDvely
.
・
SeMng from Web Browser
