P a g e
|
107
GDS3705 User Manual
Version 1.0.1.16
3.
Power ON the GDS3705. In about 10 seconds, the key pad LED lighting will change from solid
lighting to blinking, the blinking time window is about 30 seconds. The user needs to enter the
following key combination
*0#
while the LED is blinking.
Notes
:
If the correct key combination inputted, the last key input will play with a long tone, illustrating
the correct key combination entered, then the GDS3705 will get into factory reset mode.
During the blinking time window, if the user does not finish the key combination operation, or
pressed the wrong key combination, the GDS3705 will play short beep quickly three times
illustrating error. Nothing will happen and the GDS3705 will get into normal booting process.
User who wants to do hard factory reset has to perform the operation from the beginning again.
4.
After 3 ~ 5 minutes the GDS3705 will finish performing the reset process, then the user can log into
the GDS3705 web GUI using the shipped default password.
5.
User must power OFF the GDS3705, unplug the Wiegand cable, power ON the GDS3705 again
and make sure the GDS3705 is running correctly.
Restore to Factory Default Via SIP NOTIFY
1. Access your GDS3705 UI by entering its IP address in your favorite browser.
2. Go to Phone Settings # page.
3. Enable “Allow Reset Via SIP NOTIFY” by checking this option. (Default is disabled)
4. Once a
SIP NOTIFY
with “
event: reset
” is received, the GDS3705 will perform factory reset after
authentication phase.
Note:
Received SIP NOTIFY will be first challenged for authentication purpose before taking factory reset
action.
The authentication can be done either using admin password (if no SIP account is configured) or via SIP
account credentials (SIP User ID and Password).