IP PHONE – GRANDSTREAM BUDGE TONE-100 – Operating Manual
pag.5
ACCESS TO THE DEVICE
Once completed the connections, you can proceed with the configuration of your GRANDSTREAM BUDGE TONE-100.
Before proceeding with the IP phone configuration it is necessary to verify if in your router the DHCP service is working,
(this means that in your LAN are used IP addresses in a dynamic way), or if the DHCP service is not working, (this
means that in your LAN are used IP addresses in a static way).
Based on what mentioned above, please proceed with the suitable instructions that follow.
Access to IP Phone when the DHCP service is working
1.
verify that the LAN port of your PC is configured in order to obtain an IP address automatically
.
Click on “
Start \ Settings\ Network connections
“, double
click on “
Local area connections (LAN)”
.
In the new window click on
“Properties”
and then double
click on “
Internet Protocol (TCP/IP)”.
Verify that the option
“Obtain an IP address
automatically”
is activated or modify the setting and press
“
OK
” .
At the end, you can close all the opened windows.
2. verify which IP address has been assigned to your GRANDSTREAM BUDGE TONE-100.
Access your router in configuration mode and in the status information about the “LAN” or on “DHCP client” check
which IP address has been assigned to your GRANDSTREAM BUDGE TONE-100and write it down.
3. start your Web Browser (i.e. Internet Explorer), insert the IP address of your GRANDSTREAM BUDGE TONE-100
and press “
GO
”.
4. It will appear the window prompt for “Password” in which
you have to insert “admin”.
Attention!
The confidentiality of these data is necessary
in order to guarantee that the equipment configuration is
accessible only by you. We suggest to proceed with the
configuration password change and to write down the
new one.
5. After few moments, the window “Grandstream IP Phone
Configuration” will appear. Here you can change the
parameters configuration of GRANDSTREAM BUDGE
TONE-100, as explained in the following chapter.
IMPORTANT:
the changes made are not going to be effective before “Save” and “Reboot” of the IP Phone, as indicate in
the following pages.
