Grandstream Networks, Inc.
BT-200 User Manual
Page 18 of 35
Firmware 1.1.1.14
Last Updated: 12/2006
Menu Item Menu Functions
10
Display “[10] Phy Addr”
Press MENU to display the physical / MAC address.
Press ‘
↓
’ or ’
↑
’ to exit.
11
Display “[11] ring 0”
Press MENU to hear the selected ring tone, press ‘
↓
’ or ’
↑
’ to select the stored ring
tones. There are 3 available ring-tones: ring 0 (default), ring 1 and ring 2. ring 3 is
unavailable or unsupported.
Press MENU to select and exit.
Factory
Reset
Display “ -- rESEt --”. Please be very
careful
when using this function.
Two options: factory reset or manual reboot.
Factory Reset
:
1. Key in the physical / MAC address on back of the phone.
2. Press MENU to reset phone to FACTORY DEFAULT settings. All your
setting will be erased.
Manual Reboot
: Press MENU without keying anything.
Others
When phone is powered on and time is displayed
Press ‘
↓
’ or ’
↑
’, Display “ ring [4] ”, press ‘
↓
’ or ’
↑
’ again to hear and adjust the ring
tone volume, from 0 (off) to 7 (maximum), off and on hook to set
Press SPEAKERPHONE button, or off hook and pick up handset, press ‘
↓
’ or ’
↑
’ to
adjust the speakerphone/headset or handset volume.
C
ONFIGURATION WITH
W
EB
B
ROWSER
The BT–200 has an embedded Web server that will respond to HTTP GET/POST requests. It also has
embedded HTML pages that allow a user to configure the IP phone through any web browser.
Access the Web Configuration Menu
The IP Phone Web Configuration Menu can be accessed by the following URI:
http://Phone-IP-Address
where the
Phone-IP-Address
is the IP address of the phone. To find your IP address, press MENU and
select the Status item to see “
IP: IP Address
”.
NOTE:
When typing the IP address into a browser, strip out the leading “0” as the browser will parse in
octet.
e.g.
if the IP address is: 192.168.001.014, please type in: 192.168.1.14.
E
ND
U
SER
C
ONFIGURATION
Once this HTTP request is sent from a Web browser, the web server will display a login screen.
The
password is case sensitive with maximum length of 25 characters. The factory default password for the
End User is “
123
”. After login, the embedded Web server will display the Configuration page, explained
in detail in Table 8.
