10
Install Igniter and LED Light Controller
Batteries
4
Spark Electrode Tip
Spark Gap 1/8"
Spark Receiver
Install Cooking Components
Place Cooking Grids on Bowl Ledge.
6
When you have finished assembling your grill,
be sure that all screws are tightened for safe
operation of your grill.
CAUTION: The Grease Tray should be inspected
before each grill use to be sure there is no exces-
sive grease buildup. Clean the Tray frequently to
eliminate grease build-up and to prevent grease
fires.
Final Grill Assembly Step
Remove Caps from the Electric Ignitor Bracket.
Place 1 AA and 4 AAA batteries into the slots of
the Electric Ignitor and LED Light Controller as
shown below. (Note: The positive pole of the AA
battery must face towards the cap. For the AAA
batteries, 2 batteries must have the positive pole
facing towards the cap and 2 batteries must have
the negative poles facing away from the caps).
Position the caps onto the slots, and tighten them
onto the Electric Ignitor Bracket.
This test will ensure that the Spark Electrode Tips
are correctly positioned so your grill lights easily
and properly.
Burners Electrode Check Perform this
Electrode Check with the assistance of
another person
5
AA Battery may be installed backwards.
Electric wires may be loose. Remove the AA
battery and inspect the Ignitor Junction Box
found underneath the Electric Ignitor Bracket
-
-
•
If the gap between the Spark Electrode tip and
receiver is more than 1/8" wide, use needle
nose pliers to gently squeeze the Ignition Elec-
trode to narrow the gap.Try the Electrode Check
again. If no "clicking" sound is heard:
Be sure all Control Knobs are set to "OFF"
and open the Grill Lid.
Have your assistant stand behind you to the
right of the grill and look at both the front and
rear burner locations of the grill bowl.
Never
put
your face inside the Grill Bowl.
Select any one of the Burner Control Knobs.
Turn Control Knob to and push in. Have your
assistant watch for a blue spark within the
Ignition Electrode. Repeat process to test
other burners.
If no spark is seen, the Spark Gap needs to
be adjusted as follows:
and reconnect any
loose wires.
Note: Press the Switch Button to turn on the LED
Light Controller before using the grill. Press it
again to turn off the LED Light Controller to save
battery power when the grill is not in use.
Switch Button OFF
Switch Button ON
Cap of LED
Light controller
Cooking Grids