Grand Effects
Fire Pits (Manual Operation)
Operating and Maintenance Instructions
www.grandeffectsinc.com
949-697-5270
5
Section 3: Burner Setup and Adjustment
Note:
Each burner should have a flame height of approximately 12
″ – 15″ from the top
of the bowl.
1. The height of the flame can be adjusted at each burner by opening or closing the
1/2
″ gas valve or keyed valve as shown in Figure 2.
Each burner should be adjusted as required so that the flame size at each bowl
is similar in appearance to each other.
2. After all burners have been adjusted, make sure that the burner assembly is
repositioned so that it is sitting level in each bowl.
3.
Install decorative rock or glass on top of the “burner support” and burner
assembly. Larger lava rock is recommended (2
″ - 4″ in size). It will work better
than smaller rock.
Note:
Do not use glass with propane installations. (If you use glass with natural
gas, you will need to lay down a pre-cut stainless mesh screen to prevent glass
from falling through.
WARNING!
Do not use fire glass with propane installations.
CAUTION!
Use only approved decorative media to cover the burner assembly.
Lava and tumbled lava/ceramic stone and fire glass are all accepted media.
However, use caution when in the immediate area, as pieces may pop or explode
when exposed to heat or when wet and exposed to heat.
