12
Plumbing Systems
Storage and Transit
Anytime the RV is not intended to be used, it is considered to
be in storage or transit . To prepare the water heater, follow the
below steps:
1 . Turn off gas supply .
2 . Turn off water heater main switch .
3 . Drain water out of the system and
water heater by removing the filter
cover and drain plug (
Fig. 31
)
4 . If freezing conditions could occur,
then then the water heater
must
be
winterized
appropriately per the
instructions on
page 9
.
Routine Inspection
Routine inspection is critical for maintaining proper operation
of your appliance . Unless specified, review the following items
yearly or before each season:
1 . Inspect the gas system and installation every two years,
or otherwise specified by your RV coach manufacturer,
by a qualified personnel .
2 . Inspect for cracks, separation, peeling of seals to the RV
wall . Remove and re-seal as necessary (caulking or tape)
between the side wall and the door of the water heater
and ensure that the unit is solidly mounted to the vehicle .
3 . Verify that the air inlet openings (louvers) are completely
open and clear of any debris including mud, leaves, twigs,
insects, etc . Remove all obstructions to allow full air flow .
4 . Insects, including wasps and spiders, can build nests in
the exhaust tube outlet which will affect the performance
of the unit . Inspect the flue outlet tube to make sure that
it is unobstructed and that the screen is clean . If debris
or insects are present, clean and vacuum to remove any
remaining debris . The use of any type of after-market
screen to cover the vent is not permitted and will void the
warranty .
5 . Open the door and verify that no debris or extraneous
combustible materials are present anywhere (especially in
the area of the burner and the gas controls) . Remove any
item present and wipe clean the bottom of the housing .
6 . Inspect the interior surface of the housing for any cracks
or corroded areas that could allow penetration of gases
into or out of the interior of the vehicle .
• Check especially around the hot water, cold water,
gas and electrical connections .
•
NOTE:
If damage is found, please contact a technician
to repair or contact Furrion customer service .
Burn or Scald Hazard
• NEVER perform work
while the water heater
is operating .
• NEVER perform work
without turning the
Electrical and LP
gas supply off .
• NEVER perform work
when the appliance
is hot .
• NEVER actuate the
pressure relief valve as
long as the appliance
is still hot .
• NEVER actuate the
Drain Plug as long as
the appliance is under
water pressure and/or
is still hot .
WARNING
Always wear protective
gear such as gloves,
eyewear and clothing
to avoid injuries during
installation and servicing
of the product .
CAUTION
