4
2.0 PRODUCT INFORMATION
The Conforto KLE warm air electric furnace shall be installed in the up flow position only. This
appliance may be used with a central heat-pump or central cooling system.
INSTALLATION OVERVIEW
Install this appliance in accordance with these instructions and all national and local building/safety
codes and requirements.
Only connect this furnace to a duct system with a maximum static pressure of 0.50” W.C. Static
pressures in excess will result in reduced air flow and potential elevated discharge air
temperatures during heating cycles and reduced discharge air temperatures during cooling
cycles.
Do not operate this furnace without both supply and return air ducts installed with air filters in place
or with less than 0.20” W.C, external static pressure.
INSPECTION
As soon as you receive this unit un package and inspect it thoroughly to ensure that no damage
has resulted during the shipping process.
3.0 INSTALLATION
General
These furnaces must be properly installed in compliance with all national and local safety standard
codes. This appliance requires 240Vac single phase, 60Hz voltage. The supply power lead shall
enter the control enclosure of the furnace through the knockout provided on the right-hand side of
the furnace. This will ensure the required separation between the low voltage and high voltage
leads.
Knockouts are provided for 120Vac and 24Vac connections for humidifiers and electronic air
cleaners on both sides of the furnace.
Always ensure that the installation protects all electrical components from exposure to water.
Attention must be given to the placement of A/C coils and drains.
ATTENTION:
the front of the appliance must always remain accessible to allow maintenance and
service.
Due to the hazardous nature of electrical and mechanical requirements only trained and
qualified personnel should install and service heating and cooling equipment.
Summary of Contents for Conforto KLE 10 TO 27kW
Page 14: ...14...
