4. Location of changing table
Take care to locate the changing table so as to avoid pinching hazards. The distance to any adjacent fitting must be
at least 50 mm.
If the distance from the changing surface to a wall or an adjacent fitting is less than 50 mm, a pinching hazard exists.
It is the responsibility of the installer and the user to locate the changing table so that pinching hazards are avoided.
Adjust the feet so that the table is standing stable at the floor.
5. Functional test
Minimum distance to any adjacent fitting must be at least 50 mm.
If the distance from the changing surface to a wall or an adjacent fitting is less than 50 mm, a pinching
hazard exists.
Check that the changing table is firmly in place. If necessary, adjust the adjustable feets under the frame.
Run the changing table down and up all the way to respectively end position. Check that it moves freely,
without hindrance and jarring sounds.
Check that no cables are jammed.
If the changing table does not reach the lowest position:
Press the down button for 5 seconds until the control box clicks. When the control box clicks the
synchronisation is ok.
Model with sink:
Run the changing table to the end position and make sure the hoses are long enough above the fixing point.
Granberg Interior AB - Box 6112 - 600 06 Norrköping - SWEDEN
Tel: +46-11 19 77 50 - E-mail: [email protected] - Internet: www.granberg.se
