EN
7
3
Installation
B
Please remember that the
manufacturer shall not be held liable if
the information given in the user guide
is not observed.
Points to be considered
when re-transporting your
freezer
1. Your freezer must be emptied and
cleaned prior to any transportation.
2. Shelves, accessories, and etc. have to
be fastened securely by adhesive tape
against any jolt before repackaging.
3. Packaging must be tied with thick
tapes and strong ropes and the
rules of transportation printed on the
package must be followed.
Please do not forget…
That recycled material is an
indispensable source for the nature
and for our national resources.
If you would like to contribute to the
recycling of the packaging materials,
you can get further information from
the environmental bodies or local
authorities.
Before operating your
refrigerator
#FGPSF TUBSUJOH UP VTF ZPVS GSFF[FS
check the following:
1. The interior of the refrigerator has to
be dry and it is possible for the air
to circulate freely at the back of the
appliance.
2. You can install the 2 spacers as
illustrated in the figure. Spacers will
provide the required distance between
your freezer and the wall in order to
allow the air circulation. (The illustrated
figure is only an example and does
not match exactly with your product.)
3.
Clean the interior of the freezer
BTSFDPNNFOEFEJOUIFi.BJOUFOBODF
and cleaning” section.
4. Plug the frezer into the outlet. When
the freezer door is open the interior
light in the freezer will be switched on.
5. You will hear a noise as the
compressor starts up. The liquid and
gases sealed within the refrigeration
system may also give rise to noise,
even if the compressor is not running
and this is quite normal.
6. The front edges of the freezer may
feel warm. This is normal. These areas
are designed to be warm to avoid
condensation.
