GF8903P-INS-LAB-RevB11
1
GF8903P: OVERBED TABLE, NON-TILT
ASSEMBLY & OPERATION INSTRUCTIONS
PLEASE SAVE THESE INSTRUCTIONS FOR FUTURE USE
Note: The most current version of these instructions can be found online at
www.grahamfield.com
Tools needed:
5
/
8
wrench, M6 hex key (included)
IMPORTANT SAFETY INFORMATION: PLEASE READ
WARNING: Important! Read and understand these instructions before assembling or using the
GF8903P Overbed Table. If you do not understand any part of these instructions, contact a
healthcare professional for direction in the use of this product. If the overbed table is not prop-
erly assembled and adjusted, personal injury and/or damage to the overbed table could result.
WARNING: If components are damaged or missing, contact your dealer immediately. DO NOT
use substitute parts. Use only Lumex
®
replacement parts. Non-Lumex
®
replacement parts
could cause personal injury and/or damage to overbed table.
WARNING: GF Health Products, Inc. assumes no responsibility for any damage or injury
caused by improper assembly or use of this product.
UNPACKING
Check for any obvious damage to the carton or its contents. If damage is evident, DO NOT USE. Con-
tact carrier / distributor for further instruction.
ASSEMBLY
WARNING: The column is telescoping and
spring-loaded — handle with care during
assembly. DO NOT disassemble the column;
this could cause serious personal injury.
1. Place table top upside down on a level surface
as shown at right.
2. Position column bracket above table top brack-
et as shown at right, with holes matched, and
lower column onto table top. Insert socket head
cap screws through column bracket into table
top bracket as shown. Use M6 hex key to tighten
the screws.
3. Place the base upside down above the col-
umn as shown at right. Install the two large
hex bolts through the bolt plate, base, and into
column end as shown. Use
5
/
8
wrench to tighten
the bolts.
4. Note position of casters, facing away from table
top, with the two locking casters at the column
end of the base. Insert caster bolts into base as
shown at right. Screw casters in securely.
5. TURN THE TABLE UPRIGHT and place it on the
floor.
WARNING: Ensure that the table is assem-
bled as described, and that all components
are securely attached, before use.
Assembly
column bracket
socket head cap screw
(3 each)
release lever
table top
bolt plate
large hex bolt
(2 each)
table top bracket
column
non-locking caster
(2 each)
locking caster
(2 each)
base
