ATTACHING THE LEG EXTENSIONS
(IF NOT ATTACHED ALREADY)
1.
Place frame on its side on a level surface.
2.
Attach leg extensions with suction feet to the frame on the same side
as where the support arm will be. Attach leg extensions with flange
tips to frame on opposite side of frame.
3.
The transfer bench legs with suction feet should be the two legs that
are to be placed inside the tub.
NOTE:
Ensure seat support tubes buttons protrude fully through channel
guide holes.
ATTACHING THE BACKREST
1.
Determine the side on which the backrest should be mounted by knowing
which direction the user will face when sitting on the bench in the tub.
2.
Position the bench upright on a level surface.
3.
Locate the channel guides (4 each) on underside of seat. Align
backrest support tubes with channel guides.
4.
Slide backrest seat support tubes through channel guides until seat
support tube push buttons protrude fully through channel guide holes.
NOTE:
Ensure seat support tubes buttons protrude fully through channel
guide holes.
CAUTION:
Backrest is not designed to support the full weight of the user.
CAUTION:
Ensure backrest is facing down correctly before inserting to
avoid improper installation.
ADJUSTING LEG HEIGHT
1.
Depress the height adjustment button and slide the lower leg upward
or downward until the height adjustment button clicks into place in the
desired hole.
2.
Repeat for other 3 legs.
CAUTION:
Ensure that all four legs are adjusted to the same height, and that all
height adjustment buttons protrude fully through adjustment holes before use.
ATTACHING THE SUPPORT ARM
1.
To attach the support arm, position the seat arm against the leg frame
and slide the armrest tubing into the tube openings until it clicks into
place. Make sure that the push buttons fully protrude through the holes
in the bracket.
NOTE:
An audible “click” will be heard.
2.
To remove the support arm, depress the push buttons and pull up.
NOTE:
The end with the Support Arm and Suction Feet is the side that
should be inside the tub.
